The cap of the handle (metal) is a stylish car accessories for Citroen C-2 (07.03+). Quickly installed, are securely held and firmly resistant to any mechanical and environmental impacts.
When ordering, send a photo of your native pens to the managers! Do you want to distinguish your AUDI A3 car from the mass of similar ones? Then you will have to take care of its tuning and decorate it with chrome parts, including buying OMSA handle covers (4 pieces in the set).
Pads on handles is autotower for tuning the Citroen Berlingo. Accessories made of steel, are mounted on adhesive tape (included), not oblazit and does not corrode. Set - 3 PCs
Pads for steel knob for tuning Mitsubishi Grandis - a commodity that is in high demand among motorists all over the world. Due to steel composition, manufacturing technology and polishing pads have a high resistance to external influences. Manufacturer - Turkey. Set - 4 pieces.
Steel protection handles made in the form of overlays, which are mounted on top of the regular pens. Accessories are for tuning Nissan Primera III. Manufacturer - Turkey.
They are applied over the factory handles with double-sided tape, so no drilling is needed. Before installation, the handles are washed, degreased, and dried, and the trim is test-fitted first.
These are trims with a cutout for the button or sensor for keyless access on the handle. If your car’s driver-side handle does not have such a button, choose the version without a chip. There is no electronics in the trim.
Full trims cover the handle from the top and side. Narrow, flat, and end-cap trims cover only the front part or the end of the handle and look more discreet.
Both brands make trims from stainless steel. Carmos uses Turkish steel and offers the widest model range. Omsa Line is Italian stainless steel from a Turkish manufacturer with a more precise fit: the trim follows the shape of the handle more closely.
No. Handle trims are attached to the handle itself, while under-handle trims, also called “soap dishes” or “cups,” are installed in the recess under it to keep the paint from being scratched by nails. These are different products, and both are available in the section.
No, the trim is glued over the existing factory handle and only hides wear marks. For Land Cruiser 200, Prado 150, and Lexus LX, the section includes complete door handles.
How it works
Fit the covers Place each cover against its handle without removing the protective film from the tape, and make sure it sits evenly and the cutouts align with the button or key cylinder.
Wash and dry the handles Remove dirt, wax, and polish residue from the handles, then let the surface dry completely.
Degrease the surface Wipe the handles with a degreaser or an alcohol wipe — this affects how firmly the tape will hold.
Warm it up in cool weather Apply in dry warmth. If it’s cold, gently warm the handle and the tape with a hair dryer.
Apply and press down Remove the film, install the cover in place, and press it firmly along the entire perimeter, especially the edges.
Let the tape set Do not wash the car immediately after installation so the tape has time to bond properly.