Opel Universal Mud Flaps Polytep (230*375, 2 pcs)

Description

Polytep 230×375 mud flaps — a pair of rubber mud flaps with a white OPEL lettering sized 23 × 37.5 cm and 0.35 cm thick. These are not vehicle-specific mud flaps for a particular body, but limited universal ones: they fit various Opel models, but the position and mounting are selected on your own car according to size.

What size and shape the Polytep 230×375 mud flaps have

• Width — 23 cm, height — 37.5 cm, thickness — 0.35 cm.
• Material — rubber, color black, OPEL lettering white.
• Package contents — 2 pcs.: left and right mud flap, mirrored to each other.
• Manufacturer — Polytep.

The top edge of each mud flap has a curved cutout to match the contour of the wheel arch, and on the side — a narrow tab with two mounting holes. The lower part is straight, so the mud flap covers the wheel across the full width and catches dirt and small stones that would otherwise fly onto the sills, doors, and bumper.

The mud flaps are mirrored, so before installation lay them out by sides according to the shape of the arch cutout: the left goes only on the left, the right — on the right, and the OPEL lettering on both reads normally. If you swap them, the cutout won’t match the arch, and the lettering will end up upside down. A pair is used for one axle; for front and rear wheels you will need two sets.

How to tell if they will fit your Opel

The 230×375 mm size is one of the most common for passenger cars. Before ordering, measure the space behind the wheel on your Opel: the width from the tire edge to the edge of the arch and the distance from the bottom of the bumper or sill to the road. The mud flap should cover the tread, but not protrude beyond the vehicle’s body dimensions and not catch on curbs. If the wheel is wide or the car is tall, a larger size is better — Polytep 280×440 (28 × 44 cm). Sills, trim pieces, or a body kit near the arch change the mounting position, so take those into account too.

How to install universal mud flaps

1. Test-fit the mud flap to the arch and determine where the tab with holes lines up with the edge of the fender liner or bumper.
2. Mark the mounting points so that the bottom edge sits level and at the same height on both sides.
3. Secure the mud flap through the holes in the tab; the fasteners are not specified in the package contents, so prepare self-tapping screws or clips in advance.
4. Check that when turning the steering wheel, the tire does not touch the mud flap.

The rubber is soft, so the mud flap won’t crack with light contact with a curb or snow. Other options for the brand — in the universal Opel mud flaps section and on the all mud flaps for Opel page; for the interior, Opel badges for floor mats are a good addition.

The description was prepared with the help of AI based on the analysis of more than 1 million phone calls between DD Tuning managers and customers, as well as the company’s knowledge base. We collected the questions customers ask most often and answers verified in practice.