In this publication you will learn how to make a Shumka floor of a Lada Priora with your own hands and what tools and materials are needed for this.
Author: Radomskyi Maksym VasyliovychIn our previous publications, we got acquainted with the process of soundproofing Priora doors and roofs . Now we propose to learn how to make a Shumka floor of Lada Priora with your own hands.
Tools and materials
First of all, consider the list of necessary materials and tools that will be needed for the job:
- Hair dryer industrial.
- Rags.
- Scissors, knife.
- Screwdriver.
- Degreaser, for example - gasoline "Kalosha".
- Special roller for rolling.
- Vibration isolation material.
- Soundproofing material.
Recommendations
To ensure that the work goes quickly and efficiently, we offer the following list of recommendations:
- If you plan to carry out this work yourself, then it will be useful to wrap the wires with tape or adhesive tape every 30 cm.
- It is recommended to replace the fixing bolts and screws with longer ones, as the old ones may no longer fit due to the Shumkov layer.
- When applying the material to hard-to-reach places, it is recommended to cut the noise into smaller pieces.
Step-by-step guide for soundproofing the Priory floor
So, the process itself looks like this:
- First of all, the seats, the gearbox console, and the flooring are dismantled from the passenger compartment.
- Next, we clean the surface of the bottom from dirt, dust, remove possible rust and degrease. If there is factory soundproofing, we also remove it. Leave for time to dry.
- After that, we apply the first layer - a vibration isolator. At the same time, we heat the material with a hairdryer and carefully roll it with a special roller. Important: there should be no air bubbles.
- The second layer is glued soundproofing. Here, a hair dryer is no longer needed, the material has its own adhesive surface. In the area of the gearbox console, it is better to use thinner material (2 mm).
- The process of soundproofing the bottom can be considered complete. Now all interior elements are mounted in the reverse order.
By the way, on this topic, you can also read the article: Do-it -yourself noise isolation of the car floor , published on our website earlier.
This material was prepared using AI tools for topic research, structuring and initial draft creation. Fact-checking, editing, expert review and final approval were performed by Maksym Vasyliovych Radomskyi.
